Alternate Trigger - Owon SDS5052E-V User Manual

Mode
Holdoff

Alternate trigger

Trigger signal comes from two vertical channels when alternate trigger is on. This mode is
used to observe two unrelated signals. You can choose different trigger modes for different
channels. The options are as follows: edge, video, pulse or slope.
1. Alternate trigger (Trigger mode: Edge)
Alternate trigger (Trigger Type: Edge) Menu is shown as Figure 5-22.
Figure 5-22 Alternate trigger (Trigger Type: Edge) Menu
Alternate trigger (Trigger Type: Edge)
MENU
Alternate Mode
Source
Coupling
5.Advanced User Guidebook
Select pulse width condition and adjust the M knob
to set time.
Auto Acquire waveform even no trigger occurred
Normal Acquire waveform when trigger occurred
Single When trigger occurs, acquire one waveform then stop
Holdoff 100 ns - 10 s, adjust M knob to set time interval
before another trigger occur.
Reset Set Holdoff time as 100 ns
Menu
SETTING INSTRUCTION
Edge Set vertical channel trigger type as edge trigger.
CH1 Select CH1 as the trigger source.
CH2 Select CH2 as the trigger source.
AC Not allow DC portion to pass.
DC Allow all portion pass.
HF Not allow high frequency of signal pass and only
low frequency portion pass.
LF Not allow low frequency of signal pass and only
high frequency portion pass.
(SDS5032E(V), SDS5052E(V) do not have HF and LF)
list:
39