Bus Decoding (Optional) - Owon XDS3204E User Manual

Custom
Baud
Start
Type
ID
Data
Condition
ID&Data
End
Missing
Ack
Bit
Stuffing
Mode Auto
Normal
Holdoff Single

Bus Decoding (Optional)

1. RS232 Decoding
To decode RS232 signal:
(1) Connect the RS232 signal to the Signal Input Channel of the oscilloscope.
(2) Adjust to the proper time base and voltage division.
4.Advanced User Guidebook
Turn the M knob (or tap on
the Baud. The range is 10,000 to 1,000,000.
Tip: You can select the nearest value in Common Baud,
and then adjust it in this menu.
Trigger on the start frame of the data frame.
Data
Type
Remote
(Bottom
Error
menu)
Overload
Configure Format
(Bottom
ID
menu)
Byte
Configure Length
(Bottom
Data
menu)
Format
ID
Configure
Byte
(Bottom
Length
menu)
Data
Trigger on the end frame of the data frame.
Trigger on Missing Ack.
Trigger on Bit Stuffing Error.
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
56
in touchscreen) to set
Trigger on the selected frame.
Select Standard or Extended.
Use the M knob and Direction
key on the front panel to set.
Set the number of bytes with the
M knob. The range is 1 to 8.
Set the data with the M knob
and Direction key on the front
panel.
Select Standard or Extended.
Use the M knob and Direction
key on the front panel to set.
Set the number of bytes with the
M knob. The range is 1 to 8.
Set the data with the M knob
and Direction key on the front
panel.