Owon XDS3204E User Manual page 50

slope
When
High level
Threshold
Low level
&SlewRate
Slew rate
Auto
Normal
Single
Mode
Holdoff
Holdoff
Reset
4. Pulse Width Trigger
Pulse trigger occurs according to the width of pulse. The abnormal signals can be
detected through setting up the pulse width condition.
In Pulse Width Trigger mode, the trigger setting information is displayed on bottom
right of the screen, for example,
is pulse width, trigger source is CH1, coupling is DC, polarity is positive, and trigger
level is 0.00mV.
Pulse Width Trigger menu list:
MENU SETTING
Single Mode
Source
Coupling
4.Advanced User Guidebook
Slope selecting
Set slope condition; turn the M knob or click
set slope time, press
to move cursor to choose which digit to be
set.
Adjust M knob to set the High level upper limit.
Adjust M knob to set Low level lower limit.
Slew rate = (High level - Low level) / Settings
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
100 ns – 10 s, turn the M knob or click
time interval before another trigger occur, press
panel button or click
choose which digit to be set.
Set Holdoff time as 100 ns
INSTRUCTION
Set vertical channel trigger type as pulse trigger.
Pulse
CH1 Select CH1 as the trigger source.
CH2 Select CH2 as the trigger source.
AC Not allow DC portion to pass.
DC Allow all portion pass.
43
panel button or click
to set
to move cursor to
，indicates that trigger type
to