Owon XDS3204E User Manual page 16

Trig: Trigger detected and acquire waveform.
Ready: Pre-triggered data captured and ready for a trigger.
Scan: Capture and display the waveform continuously.
Stop: Data acquisition stopped.
4. Click to show/hide the touchable menu pane (only for touchscreen). (see "Operate the
Menu through Touchscreen" on P17)
5. Turn on/off the magnifier function
6. The two blue dotted lines indicates the vertical position of cursor measurement.
7. The T pointer indicates the horizontal position for the trigger.
8. The pointer indicates the trigger position in the record length.
9. It shows present triggering value and displays the site of present window in internal
memory.
10. Touchable icon is to enable (
for touchscreen).
11. It shows setting time (see "Config" on P81).
12. Wi-Fi is activated (see "Communication with Android Device via Wi-Fi (Optional)"
on P122).
13. It indicates that there is a USB disk connecting with the oscilloscope.
14. Indicating battery power status (see "Display" on P81).
15. Multimeter window.
16. The pointer shows the trigger level position.
17. The waveform of CH1.
18. The two blue dotted lines indicate the horizontal position of cursor measurement.
19. The waveform of CH2.
20. It indicates the measured type and value of the corresponding channel. "T" means
period, "F" means frequency, "V" means the average value, "Vp" the peak-peak value,
"Vr" the root-mean-square value, "Ma" the maximum amplitude value, "Mi" the
minimum amplitude value, "Vt" the Voltage value of the waveform's flat top value,
"Vb" the Voltage value of the waveform's flat base, "Va" the amplitude value, "Os"
the overshoot value, "Ps" the Preshoot value, "RT" the rise time value, "FT" the fall
time value, "PW" the +width value, "NW" the -Width value, "+D" the +Duty value,
"-D" the -Duty value, "PD" the Delay A->B
"TR" the Cycle RMS, "CR" the Cursor RMS, "WP" the Screen Duty, "RP" the Phase,
"+PC" the +Pulse count, "-PC" the - Pulse count, "+E" the Rise edge count, "-E" the
Fall edge count, "AR" the Area, "CA" the Cycle area.
21. The icon shows the selected trigger type, e.g.
edge for an Edge trigger. The reading shows the trigger level value of the
corresponding channel.
22. Channel identifier of current bottom menu.
23. The readings show the record length.
24. The frequency of the trigger signal.
25. The readings show current sample rate.
3.Junior User Guidebook
(Only for XDS3102AP/XDS3202A with touchscreen)
) or disable (
value, "ND" the Delay A->B
9
) the touchscreen controls (only
represents triggering on the rising
value,