Alternate Trigger (Trigger Mode: Edge); Logic Trigger - Owon XDS3000 Series User Manual

Auto
Normal
Single
Mode
Holdoff
Holdoff
Sensitivity

Alternate Trigger (Trigger mode: Edge)

Trigger signal comes from two vertical channels when alternate trigger is on. This
mode is used to observe two unrelated signals. Trigger mode is edge trigger.
Alternate trigger (Trigger Type: Edge) menu list:
Menu Settings
Alternate
Edge
Mode
CH1
Source
CH2
AC
Coupling
DC
Slope
Auto
Holdoff
Mode
Holdoff
Sensitivity

Logic Trigger

Trigger according to logic relation.
In Logic Trigger mode, the trigger setting information is displayed on bottom right of
the screen, for example,
trigger type is Logic, logic mode is AND, CH1 high level and trigger level is 0.00mV,
4.Advanced User Guidebook
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
100 ns - 10 s, adjust M knob or click
interval before another trigger occur, press
panel button or click
which digit to be set.
Set channel sensitivity(Range: 0.3div-10div).
Instruction
Set vertical channel trigger type as edge trigger.
Channel 1 as trigger signal.
Channel 2 as trigger signal.
Block the direct current component.
Allow all component pass.
Trigger on rising edge
Trigger on falling edge
Acquire waveform even no trigger occurs
100 ns - 10 s, turn the M knob or click
time interval before another trigger occur, press
panel button or click
cursor to choose which digit to be set.
Set channel sensitivity(Range: 0.3div-10div).
49
to set time
move cursor to choose
to set
to move
， indicates that