Table of Contents
Advertisement
TPD/VPD Series HMI Device User Manual
6.
Power/GND Connector
The use as the power supply applies to VPD-173N/173X series models. The valid
power voltage range is from +12 to +48 V
regarding the pin assignments, refer to
7.
Rotary Switch (0 ~ 9)
The rotary switch is placed under the front cover of the TouchPAD device, please
remove this cover and use a flat-head screwdriver to set the configuration modes, as
follows:
0. Run & Update: Run or update the program. This mode is used in the development
phase.
1. Force Update: While the application run on the TouchPAD device seriously crashes,
use this mode to update a new application to the TouchPAD device throught Ethernet.
2. Run Only: Run the program.
8.
Reset Button
Use a flat-head screwdriver to press this button to reset the TouchPAD device.
button does not behave as a reboot to the whole system, only resets the microcontroller and this is
not enough to make the program downloading successful. Always cut the power then turn it on
before downloading programs.
9.
I/O Expansion Boards (Optional XV-board)
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved.
For more detailed information
DC.
Section 2.2.8 VPD-173N/173X Series
(for VPD-173X/173X-64 only)
Models.
Note: The reset
Page: 40
Advertisement
Table of Contents
