TPD/VPD Series HMI Device User Manual
Follow the procedure described below:
Step 1: Attach a power supply to the TouchPAD device. Refer to
Section 3.3 "Supply Power to the
TouchPAD"
for more details.
Step 2: Connect the TouchPAD device to the Host PC using an I-7520 module (Option).
Step 3: Use a flat-head screwdriver to set the Rotary Switch on the TouchPAD device to "Update
Only" mode (position 1). Reboot the TouchPAD device and then setting is complete.
Note that the
default configuration is "Run Only" mode (position 0).
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved.
Page: 72