Table of Contents
Advertisement
TPD/VPD Series HMI Device User Manual
For VPD-143-H/143N-H:
0. Run & Update (Ethernet): This is a special run mode which is used in the
development stage. The TouchPAD device can be updated by a PC from the remote
side through Ethernet.
1. Ethernet Force Update: While the application run on the TouchPAD device
seriously crashes, use this mode to update a new application to the TouchPAD device
through Ethernet.
2. Run Only: Run the program.
9. USB Force Update: Update a new application to the TouchPAD device through
USB.
6.
Power/GND/RS-232/RS-485 Connector
The TouchPAD device is equipped with a removable terminal block connector is
designed for easy and robust wiring. For more detailed information regarding the pin
assignments, refer to
7.
PoE and Ethernet RJ-45 Jack
The TouchPAD device is equipped with an RJ-45 jack that is used as the 10/100
Base-TX Ethernet port and features networking capabilities. When an Ethernet link is
detected and an Ethernet packet is received, the Act LED (Green) indicator will be
illuminated. When power is supplied via PoE (Power-over-Ethernet), the PoE LED
(Orange) indicator will be illuminated.
8.
USB Port
The USB Port is used to downloading application programs.
9.
I/O Expansion Boards (Optional XV-board)
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved.
Section 2.2.7 VPD-142/143 Series
(for VPD-143/143N/143-H/143N-H only)
Models.
Page: 38
Advertisement
Table of Contents
