Table of Contents
Advertisement
Remote control operation
Switching the input
The input for projection can be switched.
Press the input selection (<COMPUTER>,
<COMPONENT>, <VIDEO/S-VIDEO>,
and <HDMI 1/2>) buttons on the remote
control.
<COMPUTER>
<COMPONENT>
<VIDEO/
S-VIDEO>
<HDMI 1/2>
Note
z Each time you press the <INPUT SELECT> button,
the settings change as follows. (
[HDMI 1]
[VIDEO]
40 - ENGLISH
button
Switches to computer signal input
mode.
Switches to component (YC
YP
P
) signal input mode.
B
R
Switches to S-video/video signal
input mode. If either of the input
modes has already been selected,
switches to another input mode.
Switches to HDMI signal input
mode. If either of the input modes
has already been selected,
switches to another input mode.
page 21)
[HDMI 2]
[COMPUTER]
[S-VIDEO]
[COMPONENT]
Using the Automatic setup
function
During signal input from a computer, [SHIFT], [DOT
CLOCK], and [CLOCK PHASE] can be adjusted
automatically.
button
Press the <AUTO SETUP> button on the
remote control.
Note
z During HDMI signal input, only [SHIFT] is adjusted
automatically.
z The input search is activated when there is no
signal. (When [SIGNAL SEARCH] (
to [ON])
z When signals exceeding the dot clock 162 MHz
C
/
B
R
are input, [DOT CLOCK] (
PHASE] (
z When you activate the auto setup function on
images with blurred edges or dark images,
operation may automatically stop. In this case,
switch to a different image and press the <AUTO
SETUP> button again.
z [AUTO SETUP] is displayed on the screen while
the image is adjusted automatically.
page 62) is set
page 55) and [CLOCK
page 55) cannot be set automatically.
Advertisement
Chapters
Table of Contents
