[Projector Setup] Menu; [Status]; [Projector Id] - Panasonic PT-LZ370EA Operating Instructions (Functional Manual)

[PROJECTOR SETUP] menu

[PROJECTOR SETUP] menu
Select [PROJECTOR SETUP] from the main
menu, and select the item from the sub-menu.
Refer to "Navigating through the menu"
( page 42) for the operation of the menu

screen.
z After selecting the item, press ▲▼◀▶ to set.

[STATUS]

You can display the projector status.
1) Press ▲▼ to select [STATUS].
2) Press the <ENTER> button.
▶
z The [STATUS] screen is displayed.
[SIGNAL]
[NAME]
[FREQUENCY]
[RUNTIME]
[PROJECTOR]
[LAMP]
[SERIAL NUMBER]
[PROJECTOR]
Note
z To estimate the lamp replacement timing, check
the lamp usage time (converted value) displayed
in [LAMP RUNTIME] (
SETUP].
z The actual total usage time of [ECO] and [NORMAL]
may be shorter than the lamp usage time (converted
value).
64 - ENGLISH
Displays the input signal name.
Displays the frequency of the
input signal.
Displays the operation times of
the projector.
Displays the status and the lamp
actual usage time for each mode.
Displays the serial number of the
projector.
page 66) of [PROJECTOR


[PROJECTOR ID]

The projector has an ID number setting function, and
simultaneous control or individual control is possible
with one remote control when multiple projectors are
used side by side.
1) Press ▲▼ to select [PROJECTOR ID].
2) Press the <ENTER> button.
▶
z The [PROJECTOR ID] screen is displayed.
3) Press ▲▼ to select [PROJECTOR ID].
▶
z Select one from [ALL], and [1] to [6].
4) Press the <ENTER> button to set it.
▶
z [PROJECTOR ID] is set.
Note
z The ID number of the remote control needs to
be matched with the ID number of the projector
when the ID number is specified and individually
controlled.
z When the ID number is set to [ALL], the projector
will operate regardless of what ID number is
specified from the remote control or the computer.
If multiple projectors are used and some of
them have their IDs set to [ALL], they cannot be
controlled separately from the projectors with other
ID numbers.
z Refer to "Setting Remote control ID numbers"
( page 22) regarding the method to set the ID

number on the remote control.