[Initial Start Up]; [Projection Method]; [High Altitude Mode]; Memory] [Front/ Desk] - Panasonic PT-LZ370EA Operating Instructions (Functional Manual)

[INITIAL START UP]

Set the mode for start-up when the <MAIN POWER>
switch is turned <ON>.
1) Press ▲▼ to select [INITIAL START UP].
2) Press ◀▶ to switch [INITIAL START UP].
▶
z The setting will change as follows each time
you press the button.
[LAST MEMORY] [STANDBY]
Starts up the projector in the
[LAST mode it was in before the <MAIN
MEMORY]
POWER> switch is turned to
<OFF>.
[STANDBY] Starts up in the standby mode.
[ON] Starts projection immediately.

[PROJECTION METHOD]

You can set the projection method in accordance with
the installation status of the projector.
Change the projection method if the screen display is
upside down or inverted.
1) Press ▲▼ to select [PROJECTION
METHOD].
2) Press ◀▶ to switch [PROJECTION
METHOD].
▶
z The setting will change as follows each time
you press the button.
[FRONT/DESK]
[REAR/CEILING]
When installing on the desk, etc.,
[FRONT/DESK]
in front of the screen
When installing using the ceiling
[FRONT/
mount bracket (optional) in front of
CEILING]
the screen
When installing on the desk,
[REAR/DESK]
etc., behind the screen (using a
translucent screen)
When installing using the ceiling
mount bracket (optional) behind
[REAR/CEILING]
the screen (using a translucent
screen)
[ON]
[FRONT/CEILING]
[REAR/DESK]
[PROJECTOR SETUP] menu

[HIGH ALTITUDE MODE]

If you use the projector at high elevations (1 400 m
(4 593 ft) or higher and lower than 2 700 m (8 858 ft)),
[ON] must be set.
1) Press ▲▼ to select [HIGH ALTITUDE
MODE].
2) Press ◀▶ to switch [HIGH ALTITUDE
MODE].
▶
z The setting will change as follows each time
you press the button.
[OFF]
When using at a place lower than
[OFF]
1 400 m (4 593 ft) above sea level
When using at elevations (1 400 m
[ON] (4 593 ft) or higher and lower than
2 700 m (8 858 ft) above sea level)
Note
z Make sure to set this to [OFF] when you use the
projector at elevations lower than 1 400 m (4 593 ft)
above sea level, and set this to [ON] when you use
the projector at elevations of 1 400 m (4 593 ft) or
higher and lower than 2 700 m (8 858 ft). Failure to
do so may shorten the life of the internal parts and
result in malfunctions.
z Do not install the projector at elevations of 2 700 m
(8 858 ft) or higher above sea level. Failure to do so
may shorten the life of the internal parts and result
in malfunctions.
z The speed of the fan is raised and the operation
sound will become louder when this is set to [ON].
[ON]
ENGLISH - 65