Table of Contents
Advertisement
[NETWORK] menu
■ Error information page
▶
When [Error (Detail)] is displayed on the [Projector status] screen, click it to display the error details.
▶
z The projector may go into the standby status to protect the projector depending on the contents of the
error.
▶
zDescription of problem occurrence [FAILED]:
[MAIN CPU BUS]
[FAN]
[INTAKE AIR TEMPERATURE]
[EXHAUST AIR TEMPERATURE]
[LAMP REMAIN TIME]
[LAMP STATUS]
[APERTURE(CONTRAST-SHUTTER)]
[INTAKE AIR TEMP.SENSOR]
[EXHAUST AIR TEMP.SENSOR]
[BATTERY]
[AIR FILTER]
82 - ENGLISH
Item
There is a problem with the microcomputer circuitry. Consult your
dealer.
There is a problem with the fan or the fan drive circuit. Consult your
dealer.
The intake air temperature is too high. It may be used in an operating
environment where the temperature is high, such as near a heating
appliance, the intake port may be blocked, or the air filter may be
clogged.
The exhaust air temperature is too high. The air exhaust port may be
blocked, or the mode setting for using the projector at high elevations
may be wrong.
The lamp usage time has exceeded the specified time, and it is time
to replace the lamp.
The lamp has failed to turn on. Wait a while until the luminous lamp
cools off, and then turn on the power.
There is a problem with the contrast shutter circuitry. Consult your
dealer.
There is a problem with the sensor used to detect intake air
temperature. Consult your dealer.
There is a problem with the sensor used to detect exhaust air
temperature. Consult your dealer.
The battery replacement is required. Consult your dealer.
There is too much dust accumulated in the air filter unit.
Turn the <MAIN POWER> switch to <OFF> (
the air filter (
Description
page 97).
[OK]: Normal operation
[FAILED]: Occurrence of trouble
[WARNING]: Warning
page 36), and clean
Advertisement
Chapters
Table of Contents
