Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Switching the input signal
The input for projection can be switched.
button
1)
Press the input selection (<RGB1/2>, <DIGITAL LINK>, <DVI-D>, <VIDEO>, <SDI>, <HDMI>) buttons.
f This operation can be also performed using the buttons on the control panel.
<RGB1/2>
<DIGITAL LINK>
<DVI-D>
<VIDEO>
<SDI>
*1
<HDMI>
*1 Only for PT-DZ870E
Note
f When the optional Digital Interface Box (Model No.: ET-YFB100G) is connected to the <DIGITAL LINK/LAN> terminal, the ET-YFB100G
input changes with each press of the <DIGITAL LINK> button. The ET-YFB100G input does not change when 3D signals are input from
ET-YFB100G. In such a case, either change the input signal from 3D to 2D or change the input using the button on ET-YFB100G. The input
can also be changed using the control command of RS-232C.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
Using the status function
You can display the status of the projector.
button
1)
Press the <STATUS> button.
f The [STATUS] screen is displayed.
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 119).
62 - ENGLISH
Switches the input to RGB1 or RGB2. Switches to another input when one input has already been
chosen.
Switches the input to DIGITAL LINK.
Switches the input to DVI-D.
Switch the input to VIDEO.
Switches the input to SDI.
Switch the input to HDMI.
STATUS
INPUT
SIGNAL NAME
SIGNAL FREQUENCY
PROJECTOR RUNTIME
LAMP1
LAMP2
INTAKE AIR TEMP.
OPTICS MODULE TEMP.
AROUND LAMP TEMP.
SEND STATUS VIA E-MAIL
ENTER
CHANGE
1/5
RGB2
SXGA60+-A1
65.22kHz/ 59.99Hz
1h
11h/ ON/
1h/ ON/
31°C/ 87°F
27°C/ 80°F
31°C/ 87°F
EXIT
MENU
Advertisement
Table of Contents
