[Eco Management] - Panasonic PT-LZ370EA Operating Instructions (Functional Manual)

7) Press ▲▼ to select [TIME] or
[COMMAND], and change the settings
according to the operation instructions
of the menu.
Sets the time at which the command
[TIME]
will be executed using ▲▼ .
Selects a command to execute at the
set time from the following.
[POWER ON]
[STANDBY]
[AV MUTE]
[INPUT]
[COMMAND]
[LAMP POWER]
[IN STANDBY MODE]
[VOLUME]
8) Press ▲▼ to select [STORE], and
press the <ENTER> button.
Note
z If you try to register a setting that would cause the
lamp to flash for a short time, an error message will
be displayed on the screen and the setting will not
be registered. Set the time and command again.
z If multiple commands have been set for the same
time, they are executed in chronological order
starting from the smallest command number.
z The operating time will be the local time. (
z If an operation is executed with the remote control
or control panel of the projector or with a control
command before the command set in [SCHEDULE]
is executed, the command set with this function
may not be executed.

[ECO MANAGEMENT]

You can optimize lamp power and reduce the power
consumption according to the application.
1) Press ▲▼ to select [ECO
MANAGEMENT].
2) Press the <ENTER> button.
3) Press ▲▼▶to select an item.
[ON]
■ When [AUTO POWER SAVE] was ▶
[OFF]
set in Step 3)
[COMPUTER]
[VIDEO]
You can enable [AMBIENT LIGHT DETECTION],
[S-VIDEO]
[SIGNAL DETECTION], and [AV MUTE DETECTION]
[COMPONENT]
functions.
[HDMI 1]
[HDMI 2]
Note
[NORMAL]
[ECO]
z This setting is not available if [LAMP POWER]
(

[ON]
[OFF]
4) Press ◀▶ to switch [AUTO POWER
SAVE].
5) Press ▲▼ to select [AMBIENT LIGHT
DETECTION], [SIGNAL DETECTION],
page 71)

or [AV MUTE DETECTION].
[AMBIENT
DETECTION]
DETECTION]
DETECTION]
6) Press ◀▶ to switch the setting.
[PROJECTOR SETUP] menu
▶
z The [ECO MANAGEMENT] screen is
displayed.
page 66) is set to [ECO].
▶
z The setting will change as follows each time
you press the button.
[ON]
Enables the auto power save
[ON]
function.
Disables the auto power save
[OFF]
function.
Adjusts the lamp power according
LIGHT
to the ambient brightness.
[SIGNAL Drops the lamp power when no
signal is input.
[AV MUTE Drops the lamp power in the AV
Mute mode.
▶
z The setting will change as follows each time
you press the button.
[ON]
[ON] Enables the setting.
[OFF] Disables the setting.
[OFF]
[OFF]
ENGLISH - 67