Table of Contents
Advertisement
[DISPLAY OPTION] menu
[STARTUP LOGO]
You can set the logo display when the power is turned
on.
1) Press ▲▼ to select [STARTUP LOGO].
2) Press ◀▶ to switch [STARTUP LOGO].
▶
z The setting will change as follows each time
you press the button.
[DEFAULT
LOGO]
[DEFAULT
LOGO]
[USER LOGO]
[OFF]
*1: "Logo Transfer Software" is included in the attached CD-
ROM.
Note
z To create the image for [USER LOGO], "Logo
Transfer Software" included in the supplied CD-
ROM is required.
z The startup logo will disappear in approximately 30
seconds.
z The startup logo is not displayed even when
[USER LOGO] is selected, if the log has not been
transferred with "Logo Transfer Software".
62 - ENGLISH
[USER
[OFF]
LOGO]
Projects the Panasonic logo.
Projects the logo transferred with
"Logo Transfer Software"
*1
Disables the startup logo display.
[AUTO SETUP SETTING]
You can set the auto setup function.
Set it to [AUTO] normally.
1) Press ▲▼ to select [AUTO SETUP
SETTING].
2) Press ◀▶ to switch [AUTO SETUP
SETTING].
▶
z The setting will change as follows each time
you press the button.
[AUTO]
[AUTO]
.
[BUTTON]
Note
z This setting is enabled only when computer or
HDMI signal is input.
[SIGNAL SEARCH]
When the power is turned on, this function
automatically detects the terminal to which signals are
input and sets the function to switch.
1) Press ▲▼ to select [SIGNAL
SEARCH].
2) Press ◀▶ to switch [SIGNAL
SEARCH].
▶
z The setting will change as follows each time
you press the button.
[ON]
[ON]
[OFF]
Note
z If [ON] is set and you press the <AUTO SETUP>
button on the remote control when the selected
input is no signal, the terminal to which a signal is
input is automatically detected and switched.
[BUTTON]
Enables the auto setup function
when the projected signals are
switched to the computer signals.
Enables the auto setup function
only when the <AUTO SETUP>
button is pressed.(
page 40)
[OFF]
Enables input detection.
Disables input detection.
Advertisement
Chapters
Table of Contents
