Table of Contents
Advertisement
Projecting
Check the connections of the external devices (
turn on the power (
page 35) to start projection. Select the video for projection, and adjust appearance of the
projected image.
Selecting the input signal
Select an input signal.
1) Switch on the external devices.
▶
z Press the play button on an external device, such as a Blu-ray player. When the [DISPLAY OPTION] menu
→ [SIGNAL SEARCH] (
and starts projection.
2) Press the input selection (<COMPUTER>, <COMPONENT>, <VIDEO/S-VIDEO>, and
<HDMI 1/2>) buttons on the remote control or press the <INPUT SELECT> button on
the control panel.
▶
z Image for a signal input to the selected terminal is projected.
Attention
z Images may not be projected properly depending on the external device or Blu-ray disc, DVD, etc. to be played
back. Set [TV-SYSTEM] (
z Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from
the [POSITION] menu → [ASPECT] (
Adjusting the image
1) Adjust the angle of the projector.
▶
z Place the projector parallel to the screen, and then install it on a flat surface so that the screen becomes
rectangle.
▶
z If the screen is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.
▶
z Refer to "Adjusting adjustable feet" (
2) Remove the lens shift cover.
▶
z Refer to "Removing the lens shift cover" (
page 30), the connection of the power cord (
page 62) is set to [ON], the projector automatically searches for an input signal
page 53), [RGB/YC
C
B
R
page 56).
page 26) for details.
page 20) for details.
]/[RGB/YP
P
] (
page 53) from [PICTURE].
B
R
Projecting
page 33), and
ENGLISH - 37
Advertisement
Chapters
Table of Contents
