Panasonic PT-LZ370EA Operating Instructions (Functional Manual) page 50

[PICTURE] menu
4) Adjust [FULL SCAN(B)]/[SINGLE LINE
SCAN(B)].
▶
z Select the [PICTURE] menu → [ADVANCED
MENU] and press ◀▶ to adjust [BRIGHTNESS
B] and then [CONTRAST B].
[BRIGHTNESS B]
[CONTRAST B]
■ To set [MONITOR POSITION] ▶
You can set the display position of the input waveform
during the full scan display.
Press ◀▶ to switch [MONITOR POSITION].
z The setting will change as follows each time you
press the button.
[UPPER LEFT]
[LOWER RIGHT]
[UPPER LEFT]
[UPPER
CENTER]
[UPPER RIGHT]
[LOWER LEFT]
[LOWER
CENTER]
[LOWER
RIGHT]
50 - ENGLISH
Adjusts the black level of the
display signal to 0% (0 IRE or
7.5 IRE).
z Setting range
- 16 to +16
Adjusts the white level of the
display signal to 100% (100 IRE).
z Setting range
- 32 to +32
[UPPER CENTER] [UPPER RIGHT]
[LOWER CENTER] [LOWER LEFT]
Displays the input waveform on
the upper left.
Displays the input waveform on
the upper center.
Displays the input waveform on
the upper right.
Displays the input waveform on
the lower left.
Displays the input waveform on
the lower center.
Displays the input waveform on
the lower right.
■ To set [AUTO ADJUST] ▶
The luminance level of the output signal from a
connected external device is automatically adjusted
by setting the automatic waveform adjustment items.
1) Press ▲▼ to select an adjustment
item.
Automatic waveform adjustment
items
[START AUTO ADJUST]
[BLACK LEVEL ADJUST]
[WHITE LEVEL ADJUST]
[RGB ADJUST (BLACK)]
[RGB ADJUST (WHITE)]
2) Press ◀▶ to switch the adjustment.
3) Press ▲▼ to select [START AUTO
ADJUST], and press the <ENTER>
button.
▶
z The [PROCESSING] message is displayed.
When adjustment is complete, a confirmation
message for applying results is displayed.
4) Press ◀▶ to select [OK].
5) Press the <ENTER> button.
Note
z When [BLACK LEVEL ADJUST] is [ON], the
display signal Y (brightness) value's black level is
automatically adjusted to the 0% position.
z When [WHITE LEVEL ADJUST] is [ON], the
display signal Y (brightness) value's white level is
automatically adjusted to the 100% position.
z When [RGB ADJUST (BLACK)] is [ON], the display
signal R (Red), G (Green), and B (Blue) value's
black level are all automatically adjusted to the 0%
position.
z When [RGB ADJUST (WHITE)] is [ON], the display
signal R (Red), G (Green), and B (Blue) value's
white level are all automatically adjusted to the
100% position.
z If [WAVEFORM MONITOR] is [OFF], [AUTO
ADJUST] cannot be executed.
z Project the luminance adjustment signal of a
commercial test disk etc., and perform automatic
adjustment. However, even with an adjustment
disk, correct adjustment may not be possible if
noise is included on the disk itself or the playback
device generates noise.
Factory
default
—
[ON]
[ON]
[OFF]
[OFF]