I-View ANYCAM DM-2MIPR04 Series Manual page 65

 Email Settings: Click this button to setup the email parameters. The system can be configured to
send an Email notification to all designated receivers if an alarm event is detected, e.g., motion
detection event, video loss, tamper-proof, etc.
Before you start, please configure the DNS Server settings before using the Email function.
1. Entry the email addresses (sender's email address).
2. Entry the password and confirm the password again.
3. Entry the SMTP Server IP address or host name (e.g., smtp.263xmail.com).
4. Entry the SMTP Port, the default TCP/IP port for SMTP is 25.
5. Enable SSL function; please check the "SSL" or "Identity Verification" icon, if it is required by
the SMTP server.
6. Entry the receiver email addresses which you want to send out when alarm is triggered. You
can setup 3 emails address at a time.
7. Click "Save" icon to complete the parameters settings.
65