I-View ANYCAM DM-2MIPR04 Series Manual page 52

 Detect Area: To add new Detection Area (Max. 4 regions) and each line can setup individual
corresponding parameters. Click " Drawing " icon, then press and drag the left Mouse button to
setup the detection lines from Detect area.
 Clear: Click Clear to delete all detection regions.
 Sensitivity: Setup the senility of object detection, the high value increases the sensitivity.
 Object Percent: Setup the minimum percentage ration (target size/ image area) of effective
counting targets. Once the targets ration is smaller than the setting value, the system will ignore the
target which passing through the trigger line.
 Snapshot: Check "Snapshot" and then select the value of snap interval and Number once the event
triggers that the camera will snapshot and save into the SD card or HDD.
 Record: Check "Record" once the event triggers once the event triggers that the camera will
snapshot and save into the SD card or HDD.
 Alarm Output: Check "Alarm output" and once the event triggers, the camera will linkage to alarm
output.
 PTZ: Check "PTZ" and once the event triggers, the camera will linkage PTZ camera to move the
assign Preset point.
 Preset: Setup the Preset point for the PTZ camera move to when the event is triggered.
 Save: Click "Save" icon to store the setting.
52