Chapter 3. Running Ip Camera By Witness Pro Nvr Software; Network Deployment - I-View ANYCAM DM-2MIPR04 Series Manual

Chapter 3. Running IP Camera by Witness Pro NVR software.

3-1. Network Deployment

General Connection (without PoE)
1. Connect RJ45 Ethernet cable to a switch. Use a Category 5 Cross Cable when your network
camera is directly connected to PC.
2. Connect the power cable from the Network Camera to a power outlet.
3. If you have external devices such as sensors and alarms, make the connection from the general
I/O terminal block
Power over Ethernet (PoE)
The Network Camera is PoE-compliant, allowing transmission of power and data via a single
Ethernet cable. Follow the above illustration to connect the Network Camera to a PoE-enabled switch
via Ethernet cable.
19