Adjusting Level And Effects For Each Track (Mixer) - Yamaha RS7000 Owner's Manual

7. Adjusting Level and Effects for Each Track (Mixer)

This sub-mode is used to adjust pattern-playback volume levels, effect levels, and other parameters
individually for each track.
4 pages are available: Voice Select, Volume/Pan/Out, Equalizer, and Effect Send. The equalizer parame-
ters are available on 2 sub pages accessible via the [F1] and [F4] buttons.
Press the [MIXER] button from the PATTERN Play or Patch mode to go to the MIXER Voice Select page.
Mixer Features
G This mode functions as a "mixer" which allows
adjustment of individual track levels, pan, effect
send and other parameters during pattern playback.
G Regardless of the voices specified for the phrases
used, voices can be assigned for each style.
G Mixer parameters are also saved when a pattern is
saved to memory card or disk as an SMF (Standard
MIDI File) file.
G The mixer settings are memorized with the style.
No extra save procedure is necessary. Your mix and voice
settings are saved with the style data and are automatically
recalled whenever a style is selected. If MEMORY PRO-
TECT is ON, however (Page 261), the mix and voice settings
will not be saved and will be erased when a different style is
selected.
G Absolute and relative parameters.
Absolute parameters are parameters which directly control
the corresponding function.
Relative parameters, on the other hand, function more like
offset values which shift some other value by a specified
amount.
In the mixer sub mode, only the RANDOM PAN DEPTH
parameter is relative.
Mixer Setup Procedure
Press [MIXER] while in the PATTERN Play or Patch mode
1.
to access the Voice Select display page.
Select the track to be adjusted (Page 69).
2.
Use [Knob 1] ~ [Knob 4] to make the required settings.
3.
Press [MIXER] to go to the Volume/Pan/Out page.
4.
Use [Knob 1] ~ [Knob 4] to make the required settings.
5.
Press [MIXER] to go to the EQ 1/2 page.
6.

7. Adjusting Level and Effects for Each Track (Mixer)

Use [Knob 1] ~ [Knob 4] to make the required settings.
7.
Press [MIXER] to go to the Effect Send page.
8.
9. Use [Knob 1] ~ [Knob 4] to make the required settings.
Use the [EXIT] to move back through the EQ 1/2, Volume/
10.
Pad/Out and Voice Select pages, and finally to return to the
PATTERN Play (or Patch) mode.
NOTE
• When you need to make large value changes
rotate a knob while holding the [SHIFT] button
to change values in increments of 10 rather
than 1.
• Using the four panel EFFECT SEND/VOL-
UME knobs you can directly edit the corre-
sponding mixer parameters without having to
access the mixer displays.
Display Parameters
[1] Voice Select Page
1 2
[Knob 1] [Knob 3]
1 BANK
...................................................................... [Knob 1]
[PATTERN] → [MIXER]
3
[Knob 4]
RS7000 93
2