Yamaha RS7000 Owner's Manual page 232

1. Recording Samples (Sampling)
NOTE
• The DIGITAL and OPTICAL settings can only
be effective when the optional AIEB2 I/O
Expansion Board is installed.
• When DIGITAL or OPTICAL is selected the
digital input signal will simultaneously be out-
put via the OUTPUT connector, while the
sound produced by the RS7000 will be output
via the DIGITAL OUT and OPTICAL OUT
connectors.
• Resampling allows samples to be re-recorded
after application of filtering, effects, and other
processing. The RS7000 allows the output
from sequencer tracks to be resampled, new
samples can be created from complex combi-
nation of multiple samples and sequence
data. The entire content of a pattern can be
easily turned into a single sample. When res-
ampling it is necessary to select the sampling
destination track (the selected destination
track will not play or be sampled).
4 MONO/STEREO
[Settings] MONO L, MONO R, MONO L+R, STEREO
MONO L............ The L-channel signal will be recorded
MONO R ........... The R-channel signal will be recorded
MONO L+R ....... The L-channel and R-channel signals
STEREO ........... A stereo sample will be recorded.
Specifies whether the input signal will be recorded as a mono
or stereo sample.
5 OK
......................................................................................[F4]
Calls the sampling standby page and engages the sampling
standby mode. Pressing [STANDBY/START/STOP] has the
same effect.
Sampling Standby Page
[STANDBY/START/STOP] → [F4] or [STANDBY/START/STOP]
When this display is showing pressing the [STANDBY/START/
STOP] executes sample recording, calling the Sampling Execu-
tion page (Page 234) or the trigger wait page (Page 233).
232 RS7000
...................................................[Knob 4]
as a mono sample.
as a mono sample.
will be mixed and recorded as a mono
sample.
Only the STEREO option will be avail-
able when the DIGITAL or OPTICAL
source is selected.
SAMPLE TYPE = SLICE+SEQ
9
6
5
SAMPLE TYPE = KIT, KIT+NOTE
6 9
5
3
[Knob 1]
SAMPLE TYPE = PITCH
6 9
5
4
[Knob 1]
TRIGGER MODE
1
........................................................ [F2]
[Settings] LEVEL, MEASURE, MANUAL
LEVEL...............Sampling will begin as soon as an
input signal exceeding the specified
trigger level is received.
MEASURE ........Sampling will begin at the specified
punch-in measure, and end at the
specified punch-out measure.
MANUAL...........Sampling will begin as soon as the
[STANDBY/START/STOP] button is
pressed.
Specifies the method by which sampling will be triggered.
NOTE
When the SLICE+SEQ sample type is selected
and you want to accurately slice the sample
according to the specified note length, it is best
to set the TRIGGER MODE to MEASURE.
8
7
1 2
[Knob 4]
[F2]
8
7
1 2
[F2]
[Knob 4]
8
7
1 2
[F2] [Knob 4]