Yamaha RS7000 Owner's Manual page 250

4. The Sample Jobs
LENGTH
4
..................................................................[Knob 4]
[Settings] 0 ~ End Point
Specifies the length of the fade-in or fade-out in 100 steps.
When a fade-in is selected this parameter specifies the length
of the fade starting at the specified START or
START(ATCK) point.
When a fade-out is selected this parameter specifies the
length of the fade starting at the beginning of the fade and
ending at the specified END point.
AUDITION
5
.......................................................................[F2]
Plays the specified sample.
Plays the processed sample if pressed after [F4] (DO!) is
pressed to apply a fade-in or fade-out to the sample.
6 DO!
....................................................................................[F4]
Executes the job.
CREATE
7
..........................................................................[F3]
Saves the processed sample to the target sample number,
overwriting the original sample. If the original sample is a
Pitched Sample it will be overwritten at this point.
If the original sample is part of a Sample Kit Voice a key-
number selection page will appear.
[Knob 2]
CREATE TO
8
(Destination Key Number)
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
OK
9
......................................................................................[F3]
Saves the processed sample to the specified destination key
number.
250 RS7000
8 9
[F3]
.............................[Knob 2]
09 FREQUENCY CONVERT
Halves the sampling frequency of the specified sample. This can
be used to convert hi-fi samples to a lo-fi sound, and reduce the
sample size by half.
3
1 2
[F2]
[Knob 1] [Knob 2]
SAMPLE (Sample Number)
1
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be converted.
KEY (Key Number)
2
........................................... [Knob 2]
[Settings] C-2 ~ G8
Specifies the key number of the sample to be converted.
NOTE
This parameter is not available when the speci-
fied sample is a Pitched Voice.
AUDITION
3
...................................................................... [F2]
Plays the specified sample.
Plays the processed sample if pressed after [F4] (DO!) is
pressed to apply frequency conversion to the sample.
DO!
4
................................................................................... [F4]
Executes the job.
CREATE
5
......................................................................... [F3]
Saves the processed sample to the target sample number,
overwriting the original sample. If the original sample is a
Pitched Sample it will be overwritten at this point.
If the original sample is part of a Sample Kit Voice a key-
number selection page will appear.
6
[Knob 2]
5 4
[F3] [F4]
.......................... [Knob 1]
7
[F3]