Yamaha RS7000 Owner's Manual page 131

9 IMPORT
...........................................................................[F4]
Executes the import operation.
If the destination pattern or sample voice already contains
data the "Are You Sure? No[F2]/Yes[F3]" confirmation
prompt will appear.
Press [F3] if it is OK to overwrite the corresponding memory
contents.
Press [F2] to abort the load operation and return to the status
of the RS7000 prior to pressing the [F1] button.
NOTE
When an RM1x PATT file is imported all data
originally in the destination style number will be
erased.
[3] SCSI Setup Page
Provides access to a number of SCSI settings.
Selects the disk and partition for save and load operation.
SCSI Setup Procedure
Press [LOAD] 3 times from the PATTERN Play or Patch
1.
mode to go to the SCSI Setup page.
Use [Knob 4] (SELF ID) to set the RS7000 SCSI ID number.
2.
NOTE
The new SCSI ID number will take effect the
next time the RS7000 power is turned on (i.e.
the system is re-booted). Be sure to restart the
RS7000 (turn the power off and on again) after
changing the SCSI ID number.
Use [Knob 1] (MOUNT ID) the select the SCSI ID number
3.
of the disk to be mounted, then press [F1] to mount the
selected device.
13. Loading from Memory Card or Disk
Use [Knob 2] (MOUNT PARTITION) to select the partition
4.
to be mounted.
16 partitions are displayed in the list.
Press [F3] (NEXT) to the next 16 partitions. Press [F3]
(PREV) back to the previous 16 partitions.
Press [EXIT] 3 times to return to the PATTERN Play or Patch
5.
mode.
Display Parameters
1 2
[Knob 1] [Knob 2]
[F1]
MOUNT ID
1
.....................................................[Knob 1], [F1]
[Settings]
0 ~ 7 (the current SCSI SELF ID number cannot be
selected)
Selects and mounts the SCSI device (disk) which will be used
for file transfer.
Use [Knob 1] to select the SCSI ID number, then press [F1]
to mount the selected device. Once the selected device is
mounted it will be possible to select a partition on the device.
MOUNT PARTITION
2
........................................... [Knob 2]
Selects a partition for file transfer operations from among the
partitions available on the mounted disk.
3 SCSI SELF ID
...................................................... [Knob 4]
[Settings] 0 ~ 7 (the current MOUNT ID cannot be
selected)
Sets the SCSI ID number of the RS7000.
SELF ID changes take effect after the RS7000 has been
restarted.
4 NEXT/PREV
.................................................................. [F3]
16 partitions are displayed in the partition list.
Press [F3] (NEXT) to scroll to the next 16 partitions. Or press
[F3] (PREV) to scroll back to the previous 16 partitions.
[PATTERN] → [LOAD] × 3
4 3
[F3] [Knob 4]
RS7000 131
2