Yamaha RS7000 Owner's Manual page 219

7 Curve
15 Thin Out
Thins out the specified type of continuous data in the specified
range to save memory space.
Details are the same as the PATTERN mode (Page 143).
NOTE
The Thin Out job will not work on continuous data that
has a clock interval of greater than 60 clocks per
event.
1 3
[Knob 2]
1 Track
[Settings] 01 ~ 16, BPM, ALL
Range
2
[Settings]
Measure:Beat:Clock
001:1:000 ~ 999:16:479
Event Type
3
[Settings]
When Track is 01 ~ 16:
Event Type
............................. —
PB (Pitch bend)
CC (Control change) .........................000 ~ 127, ALL
CAT (Channel aftertouch)
PAT (Polyphonic aftertouch)
When Track is BPM:
Event Type
................................ —
BPM (Tempo)
16 Modify Control Data
Changes the values of a specified type of control change data —
pitch bend, control change, aftertouch, etc. — in the specified
range.
2
[Knob 3] [F4]
Range
.............. —
.......... —
Range
Control data changes are calculated as follows:
Adjusted gate time = (original gate time × Rate) + Offset.
If the result is outside the allowable range, the value will be set to
minimum or maximum.
Details are the same as the PATTERN mode (Page 143).
1 4 5
[Knob 2]
Track
1
[Settings] 01 ~ 16, BPM, ALL
2 Range
[Settings]
Measure:Beat:Clock
001:1:000 ~ 999:16:479
3 Event Type
[Settings]
When Track is 01 ~ 16, All:
Event Type
............................. —
PB (Pitch bend)
CC (Control changer) ....................... 000 ~ 127, ALL
CAT (Channel aftertouch)
PAT (Polyphonic aftertouch)
When Track is BPM:
Event Type
................................ —
BPM (Tempo)
Set All
4
[Settings] Off, 000 ~ 127
(-8192 ~ +8191 for pitch bend,
1.0 ~ 300.0 for BPM)
Rate
5
[Settings] 000% ~ 200%, ***
Offset
6
[Settings] -127 ~ +127 ***
(-8192 ~ +8191 for pitch bend, ***),
(-275.0 ~ +275.0 for BPM, ***)
13. The Song Jobs
2 3 6
[Knob 3] [F4]
Range
.............. —
......... —
Range
RS7000 219
4