Yamaha RS7000 Owner's Manual page 19

[PAD 1] and [PAD 2]
T
Velocity-sensitive pads for performance data entry. Tapping
these pads enters the pre-specified note data at the speci-
fied pitch. The pitch for each pad can be set by playing the
appropriate key on the keyboard while holding the [TAP]
button and [PAD 1] or [PAD 2].
The Rear Panel
1
CAUTION
POWER
ON / OFF RISK OF ELECTRIC SHOCK
ATTENTION
: RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR.
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
AC INLET
MODEL
2
POWER Switch
1
Press in to turn the RS7000 on, and press again to turn it
off.
AC INLET
2
The AC power cable supplied with the RS7000 is plugged
in here. Use only the supplied cable.
3 MIDI IN, OUT A, and OUT B Connectors
If you plan to use a MIDI keyboard or other instrument to
play and program the RS7000, it should be connected to
the MIDI IN connector.
The MIDI OUT A and B connectors can be connected to an
external tone generator or synthesizer if you want to trans-
mit performance data, button and knob operations, and pad
operations to external equipment from the RS7000.
4 SCSI Connector
External SCSI storage devices (hard disks, CD-ROM
drives, etc.) can be connected here. The connector is a 50-
pin half-pitch type.
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
MUSICAL INSTRUMENT
MIDI CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003
379U
DU CANADA.
US LISTED
IN
DO NOT OPEN
OUT A
SER. NO.
OUT B
MADE IN JAPAN
3
CARD Slot
U
Slot for memory card insertion.
4 5 6 7
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLWWING TWO CONDITIONS:
( 1 ) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,AND
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECIVED,INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
INPUT
SCSI FOOT SW CONTRAST R
FOOT SW Jack
5
An optional Yamaha FC4 or FC5 footswitch connected to
this jack can be used for start/stop, section selection, sus-
tain, or tap BPM entry.
CONTRAST Control
6
Use the CONTRAST control to achieve the best LCD dis-
play visibility (LCD visibility varies with viewing angle).
INPUT L and R Jacks
7
Analog mono or stereo signals can be connected here for
sampling (recording). Connect mono signals to either the L
or R jack.
OUTPUT L/MONO & R Jacks
8
These are the main stereo outputs from the RS7000. When
a plug is inserted into only the L/MONO output, the left- and
right-channels signals are mixed and delivered via that out-
put to allow direct connection to mono sound systems.
9 PHONES Jack
Any pair of stereo headphones with a 1/4" stereo phone
plug can be plugged in here for convenient monitoring. The
PHONES output level is adjusted via the MASTER VOL-
UME control.
The Controls & Connectors
8 9
OUTPUT
L R L/MONO PHONES
RS7000 19