VESDA -E VES-A00-P Product Manual page 61

Command
Rebuild Zone List
Start Major Fault Test
Start Minor Fault Test
Start Alarm Test
Start Air Flow Fault Test Tests the air flow sensing system by shutting down
Start Relay Test
Start LED Test
Return to Factory
Defaults
Set System Date and
Time
Smoke Scan
Start Valve Test
www.xtralis.com
Table 5-2: Detector Commands (continued...)
Description
Re-learns the list of display modules that are
assigned to the detector on the VESDAnet.
Generates a major fault on the detector and de-
energizes the fault relay for 2 minutes.
Generates a minor fault on the detector and de-
energizes the fault relay for 2 minutes.
This causes the detector to simulate a user-selected
alarm condition for a user-selected sector. The
detector will behave as if real smoke has been
detected.
Alarm relays will energize unless the detector is
disabled.
the aspirator.
Tests the available relays by activating and
deactivating as required.
Tests each LED by cycling through all LEDs on the
detector display panel.
Restores the configuration of the detector to the
initial factory default values.
Sets the detector date and time.
Causes the detector to start scanning for alarms in
all the sectors configured as in use
Causes the detector to test that all four scanning
valves close correctly.
VESDA-E VES-A00-P Product Guide
Execute From
A button Xtralis VSC
on the
Detector
Software
55