Installing the right Type-C daughterboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the right Type-C daughterboard and provides a visual representation of the
installation procedure.
Steps
1. Place the right Type-C daughterboard on the system chassis.
2. Remove the four (M2x3.5) screws that secure the right Type-C daughterboard to the system chassis.
3. Connect the flat printed cable to its connector on the right Type-C daughterboard.
4. Connect the flat printed cable to its connector on the right Type-C daughterboard.
5. Replace the (M2x5) screw that secures the flat printed cable holder to the right Type-C daughterboard.
Next steps
1. Install the
rear I/O
board.
2. Install the
dock I/O
board.
3. Install the
WWAN
card.
4. Install the
WLAN
card.
5. Install the
RF switch
board.
Removing and installing components
65