Camera; Removing The Camera; Installing The Camera - Dell Latitude 7330 Rugged Extreme Service Manual

Camera

Removing the camera

Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the fan.
7. Remove the heat-sink
8. Remove the RF switch
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the dock I/O
12. Remove the rear I/O board.
13. Remove the system board.
14. Remove the display assembly.
15. Remove the display bezel.
About this task
The following images indicate the location of the camera and provide a visual representation of the removal procedure.
Steps
1. Peel the tape and disconnect the eDP cable on the camera module.
2. Remove the two (M2x5) screws that secure the camera module to the display panel.
3. Lift and remove the camera module from the display panel.

Installing the camera

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
before working inside your
(UMA).
board.
board.
computer.
or primary M.2 2230 solid state drive.
Removing and installing components 91