Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx T8 screwdriver
● 5.5 mm Socket wrench
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
M.2 2280 solid state drive
M.2 2230 solid state drive
Handle
Keyboard
Screw type
M2x3
M2x5
M2x2
M2x3
M2x5
M3.5x9
M2.5x5
M2x3
Quantity
1
1
1
1
1
2
6
4
Removing and installing components
Screw image
2
11