Installing The Usb Type-C Board - Dell Alienware m18 R2 Owner's Manual

Steps
1. Open the latch and disconnect the USB Type-C board cable from the connector on the USB-C Type-C board.
2. Remove the three screws (M2x4) that secure the USB Type-C board to the system-board assembly.
3. Lift the USB Type-C board shield from the left side.
4. Lift the USB Type-C board from the system-board assembly.

Installing the USB Type-C board

CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the USB Type-C board and provide a visual representation of the installation
procedure.
60