About this task
The following image indicates the location of the camera and provides a visual representation of the installation procedure.
Steps
1. Replace the two (M2x5) screws to secure the camera module to the display panel.
2. Connect the eDP cable on the camera module and adhere the adhesive tape on it.
Next steps
1. Install the
display
bezel.
2. Install the
display
assembly.
3. Install the
system
board.
4. Install the
rear I/O
board.
5. Install the
dock I/O
board.
6. Install the
WWAN
card.
7. Install the
WLAN
card.
8. Install the
RF switch
board.
9. Install the
heat-sink
(UMA).
10. Install the fan.
11. Install the
base
cover.
12. Install the keyboard.
13. Install the
primary M.2 2280 solid state drive
14. Install the battery.
15. Follow the procedure in
Display hinges
Removing the display hinges
Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the
primary M.2 2280 solid state drive
4. Remove the keyboard.
5. Remove the
base
cover.
92
Removing and installing components
or
primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.