Installing The Display Bezel - Dell Latitude 7330 Rugged Extreme Service Manual

Steps
1. Remove the 4 (M2.5x6, T8) epoxy screws that secure the display bezel to the display assembly.
2. Close the lid and in sequential order, remove the 11 (M2.5x6, T8) screws that secure the display bezel to the display
assembly.
3. Use a plastic scribe to carefully pry open the top, left, and right sides of the display bezel.
NOTE: When prying open the display bezel, ensure to pry along the outside edge of the display bezel using your hand or
a plastic scribe. Using a screw driver or any sharp object may damage the display cover.
4. Flip the display bezel and disconnect the eDP cable from its connector on the LCD module.
5. Disconnect the touch cable from its connector on the touch screen board.

Installing the display bezel

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display bezel and provides a visual representation of the installation procedure.
88 Removing and installing components