About this task
The following image indicates the location of the heat-sink and provides a visual representation of the installation procedure.
Steps
1. Align the heat-sink screw holes with the system board and place it on the system chassis.
2. Replace the four (M2x5) screws (in sequential order, 1->2->3->4) to secure the heat-sink to the system board.
Next steps
1. Install the
inner
frame.
2. Install the
dock I/O
board.
3. Install the WLAN.
4. Install the
RF switch
board.
5. Install the
base
cover.
6. Install the
primary M.2 2280 solid state drive
7. Install the battery.
8. Follow the procedure in
Rear I/O board
Removing the rear I/O board
Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the
primary M.2 2280 solid state drive
4. Remove the
base
cover.
or
primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.
Removing and installing components
61