Steps
1. Align the rear I/O board with the screw holes on the system board.
2. Replace the two (M2x3) screws that secure the rear I/O board to the system board.
3. Connect the rear I/O flat printed cable.
Adhere the rear I/O flat printed cable with kapton tapes to the connector.
Next steps
1. Install the
base
cover.
2. Install the
primary M.2 2280 solid state drive
3. Install the battery.
4. Follow the procedure in
Right Type-C daughterboard
Removing the right Type-C daughterboard
Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the
primary M.2 2280 solid state drive
or
primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.
Removing and installing components
63