Steps
1. Place and align the RF switch board with screw holes on the system board.
2. Connect the flexible printed cable to the RF switch board.
Adhere the flexible printed cable with kapton tape to the connector.
3. Replace the two (M2.5x5) screws that secure the RF switch board to the system board.
4. Connect the WLAN, WWAN, and GPS antennas to the RF switch board.
Next steps
1. Install the
base
cover.
2. Install the
primary M.2 2280 solid state drive
3. Install the battery.
4. Follow the procedure in
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the
primary M.2 2280 solid state drive
4. Remove the
base
cover.
5. Remove the
RF switch
About this task
The following images indicate the location of the WLAN card and provide a visual representation of the removal procedure.
42
Removing and installing components
or
primary M.2 2230 solid state
after working inside your
before working inside your
or
board.
computer.
computer.
primary M.2 2230 solid state
drive.
drive.