Steps
1. Place the power button with fingerprint-reader board on the system chassis.
2. Replace the three (M2x5) screws that secure the power button with fingerprint reader bracket to the system chassis.
3. Connect the fingerprint reader cable to its connector on the power button board.
Next steps
1. Install the
base
cover.
2. Install the keyboard.
3. Install the
primary M.2 2280 solid state drive
4. Install the battery.
5. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the
primary M.2 2280 solid state drive
4. Remove the keyboard.
5. Remove the
base
cover.
6. Remove the
RF switch
7. Remove the
WLAN
card.
8. Remove the
WWAN
card.
9. Remove the
dock I/O
10. Remove the
rear I/O
board.
11. Remove the
express card
12. Remove the
inner
frame.
13. Remove the
GPS
board.
14. Remove the
smart card
15. Remove the
smart card reader I/O
16. Remove the fan.
or
after working inside your
before working inside your
board.
board.
reader.
reader.
board.
primary M.2 2230 solid state
computer.
computer.
or
primary M.2 2230 solid state
drive.
drive.
Removing and installing components
81