Table of Contents
Advertisement
Steps
1. Peel the tape that secures the right-fan cable to the system board.
2. Disconnect the right-fan cable from the system board.
3. Remove the two screws (M2x4) that secure the right fan to the system board and palm-rest and keyboard assembly.
CAUTION:
Do not hold the fan assembly at the center, as it may damage the center bearing.
4. Lift the right side of the right fan slightly. Then, slide the right fan to the right to remove it from the palm-rest and keyboard
assembly.
Installing the right fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the right fan and provide a visual representation of the installation procedure.
30
Removing and installing components
Advertisement
Table of Contents
