Installing the near field communication
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the near field communication and provides a visual representation of the
installation procedure.
Steps
1. Place the nfc holder in the system chassis and connect the nfc flat printed cable to its connector on the nfc holder.
2. Replace the three (M2x3) screws that secure the nfc holder to the system chassis.
3. Place the left I/O board on the system chassis.
4. Replace the two (M2x3) screws that secure the left I/O board to the system chassis.
Next steps
1. Install the
base
cover.
2. Install the battery.
3. Install the
primary M.2 2280 solid state drive
4. Follow the procedure in
Smart Card
Removing the smart card
Prerequisites
1. Follow the procedure in
2. Remove the
primary M.2 2280 solid state drive
3. Remove the battery.
4. Remove the
base
cover.
5. Remove the
express
card.
or
primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.
Removing and installing components
53