Installing The Gps Board; Left I/O Board; Removing The Left I/O Board - Dell Latitude 7330 Rugged Extreme Service Manual

Installing the GPS board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the Global Positioning System (GPS) board and provides a visual representation of
the installation procedure.
Steps
1. Place the GPS board and replace the two (M2.5x5) screws to secure it to the system chassis.
2. Route the GPS antenna through the routing guide and connect it to the connectors on the Wi-Fi board and GPS board.
Next steps
1. Install the base cover.
2. Install the battery.
3. Install the primary M.2 2280 solid state drive
4. Follow the procedure in

Left I/O board

Removing the left I/O board

Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive
4. Remove the base cover.
About this task
The following images indicate the location of the left I/O board and provide a visual representation of the removal procedure.
50 Removing and installing components
or primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.