Display Cable; Removing The Display Cable - Dell Latitude 7330 Rugged Extreme Service Manual

Steps
1. Align the left hinge and replace the four (M3x6, T8) epoxy screws to secure the left hinge to the display assembly.
2. Align the right hinge and replace the four (M3x8, T8) epoxy screws to secure the right hinge to the display assembly.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the system board.
4. Install the rear I/O board.
5. Install the dock I/O board.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the RF switch board.
9. Install the heat-sink (UMA).
10. Install the fan.
11. Install the base cover.
12. Install the keyboard.
13. Install the primary M.2 2280 solid state drive
14. Install the battery.
15. Follow the procedure in

Display cable

Removing the display cable

Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the fan.
94 Removing and installing components
or primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.