Installing The System Board - Dell Latitude 7330 Rugged Extreme Service Manual

Installing the system board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the connectors on your system board.
1. Power button board cable connector
2. WWAN card connector
3. Right Type-C cable connector
4. WLAN card connector
5. Rear I/O daughter board connector
6. Left Type-C cable connector
7. RF switch board connector
8. Dock I/O flat printed cable connector
9. Right Type-C flat printed cable connector
10. Fan cable connector
11. Left Type-C flat printed cable connector
12. eDP cable connector
13. Left I/O board flat printed cable connector
14. Express card daughter board connector
15. USH board connector
16. GPS connector
17. M.2 2230/2280 solid state drive connector
18. LED board connector
19. Hall sensor
72 Removing and installing components