7. Remove the
heat-sink
8. Remove the
RF switch
9. Remove the
WLAN
card.
10. Remove the
WWAN
card.
11. Remove the
dock I/O
12. Remove the
rear I/O
board.
13. Remove the
system
board.
14. Remove the
display
assembly.
15. Remove the
display
bezel.
16. Remove the camera.
17. Remove the
display
hinges.
About this task
The following images indicate the location of the display cable and provide a visual representation of the removal procedure.
Steps
Peel the adhesive tape off the eDP cable adhered to the display cover.
Installing the display cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display cable and provides a visual representation of the installation procedure.
(UMA).
board.
board.
Removing and installing components
95