Removing and installing components
Recommended tools
The procedures in this document may require the following tools:
•
Phillips screwdriver #0
•
Phillips screwdriver #1
•
Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type
is restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Base cover
Battery (3-cell)
Battery (6-cell)
Display cable holder
Display hinges
Graphics-card fan
Hard-drive assembly
Hard-drive bracket
I/O board
Secured to
Screw type
Palm-rest and
M2x5
keyboard assembly
Palm-rest and
M2x4
keyboard assembly
Palm-rest and
M2x4
keyboard assembly
Palm-rest and
M2x4
keyboard assembly
Palm-rest and
M2.5x5
keyboard assembly
System board and
M2x4
palm-rest and
keyboard assembly
Palm-rest and
M2x4
keyboard assembly
Hard drive
M3x3
Palm-rest and
M2x4
keyboard assembly
Quantity
Screw image
6
4
7
1
8
3
3
4
2
Removing and installing components
2
9