Mounting The Dispensing Edge Holder - Novexx Solutions ALX 73 Series Service Manual

04/13 Rev. 5.08-02

Mounting the dispensing edge holder

The dispensing edge holder is required for mounting
L-shape dispensing edges.
Both, the dispensing edge holder [35A] and the mount-
ing flange [35B] on the holding plate have two concen-
tric rings of holes on the connecting surfaces. Two pins
[35C] that fit into these holes are provided with the dis-
pensing edge holder. To secure the dispensing edge
holder so it cannot swivel, the pins are located in dia-
metrically opposite holes. By replacing the pins in adja-
cent holes, the mounting angle of the dispensing edge
holder can be adjusted in 15° increments.
Tool
8 mm hex socket screwdriver
Assembly:
1. Locate the pins [36C] in diametrically opposite
holes.
2. Fit the dispensing edge holder onto the pins at the
required angle.

Choose either inner or outer circle of holes, de-
pendent on the required angle.
3. Fix the dispensing edge holder in place with screw
[35D].
SERVICE MANUAL
ALX 73x
A
[35] Mounting the dispensing edge holder (A).
Unpacking and assembling the machine
B
19
D
C