Mounting The Dispensing Edge - Novexx Solutions ALX 73 Series Service Manual

04/13 Rev. 5.08-02

Mounting the dispensing edge

Mounting a L-shape dispensing edge
Prerequisite: Dispensing edge holder is mounted.
Tool
Hex socket screwdriver, 8 mm
Mounting:
1. Fit the dispensing edge [36A] as pictured.

Position the dispensing edge so that the inner
side plate touches the edge of the label web (mate-
rial zero line).
2. Connect the label sensor.
See chap. Label sensor 

The following optional available dispensing edges
are attached in the same way:
• Swivelling dispensing edge
• Spring-loaded dispensing edge
• Pneumatic dispensing edge
Mounting a V-shape dispensing edge
Tool
• Hex socket screwdriver, 2.5 mm
• Socket spanner, SW 16
Mounting:
1. Fit the V-shape dispensing edge [36A] in the re-
quired tilt angle as pictured.

The maximum length adjustment range is
reached with a tilt angle of 6.5° [37A].
2. Install the additional deflection roller, see
an additional deflection roller 
3. Connect the label sensor.
See chap. Label sensor 
Length adjustment:
1. Loosen the 4 set screws [38A] in the cross-beam.
2. Shift the dispensing edge to the appropriate length.

Adjustment range at 6.5° tilt angle: 173 -
421 mm. See measure x in [38B].
3. Re-tighten the set screws.
SERVICE MANUAL
ALX 73x
on page 25.
Mounting
on page 21.
on page 25.
Unpacking and assembling the machine
A
[36] Mounting a fixed L-shape dispensing edge (A).
[37] Mounting a V-shape dispensing edge.
B
x
[38] Length adjustment of the V-shape dispensing edge.
20
A
6,5°
A