Producing The Power Cable - Novexx Solutions ALX 73 Series Service Manual

04/13 Rev. 5.08-02

Producing the power cable

Connecting to the machine
The ALX 73x comes with a loose machine connector
[44].
Article number: A9546
Tool:
Screwdriver size 2
Connecting:
1. Select a 3-wire power cable with a cross section
matching the mains voltage/current in your country.
2. Strip the insulation off the power cable according to
the regulations.
3. Thread the cable end through the connector hous-
ing [45].
4. Screw the wire ends into the clamps as illustrated
[45].

Pay attention to the phase position [45L].
Mains connection
Connect the free cable end to the mains power supply.

Pay attention to the phase position [45L].
SERVICE MANUAL
ALX 73x
[44] Machine connector of the power cable.
[45] Preparing the connector.
[46] Pin assignment of the connector.
Connecting to the mains power supply
L N
GND
N L
GND
24