04/13 Rev. 5.08-01
Adjustable dispensing edge holders
Adjustable dispensing edge holder (simple
version)
Also read the notes about the standard dispensing
edge holder in chapter
Mounting the dispensing edge
holder
on page 19.
Setting range: A
= 254 mm; A
min
Tool
Hex socket screwdriver, 8 mm
Mounting:
1. Locate the pins [3A] in diametrically opposite holes.
2. Fit the dispensing edge holder onto the pins at the
required angle.
Choose either inner or outer circle of holes, de-
pendent on the required angle.
3. Fix the dispensing edge holder in place with screw
[3B].
Length adjustment:
1. Define the required length.
Read the notes in chapter
dispensing edge holder
With the optional available rods in different
lengths, the adjustment range can be extended,
see chapter
Längentabelle für verstellbaren
Spendekanten-Halter
2. Loosen the clamp lever [3C].
3. Shift the lower part of the dispensing edge holder to
the appropriate length.
4. Tighten the clamp lever.
SERVICE-MANUAL
= 419 mm [4]
max
Configuring the
on page 16.
auf Seite 53.
ALX 73x
C
[3] Mounting the adjustable dispensing edge holder.
[4] Setting range of the adjustable dispensing edge holder.
Installation / Deinstallation
Mounting of options
B
A
48