MIO–CCE–4K/3G
SMPTE ST 2110/4K/3G/HD/SD Closed Caption Encoder with Media–to–IP Streaming
4.7.2. ANC (S2110-40) IP Input (not used at time of writing)
MultiCast IP: Set the multicast IP address for ANC data input.
Port: Set the port for ANC input.
Active Route: Displays the active route for ANC input.
Rx Bandwidth: Displays bandwith being received for ANC input (in Kbps).
RTP Sequence Error Count: Displays the error count for RTP data packets.
4.7.3. Mio-cce-aux-io IP Input
(Available with MIO-CCE-AUX-IO enabled)
Select stream 1 or 2
Multicast IP: Set the multicast IP for serial/GPIO input to IP.
Port: Set the port for serial/GPIO to IP.
Active Route: Displays the active route for serial/GPIO stream.
Rx Bandwidth: Displays the bandwidth being received for serial/GPIO.
RTP Sequence Error Count: Displays the error count for RTP data packets.
Serial Port Status (Port 1-4): Displays current status of serial input signal, green indicates healthy signal
red indicates error or unhealthy signal on that port.
Page - 16
Revision 1.0