Snmp Trap Servers; Timing; External Genlock Faults; Genlock Input Status - evertz MIO-CCE-4K/3G User Manual

MIO–CCE–4K/3G
SMPTE ST 2110/4K/3G/HD/SD Closed Caption Encoder with Media–to–IP Streaming

4.3.3. SNMP Trap Servers

This section contains controls for connecting for setting trap server for alarms, with the possibility to connect
up to three trap servers.
Trap Destination Enable: This control will enable or disable the designated trap server.
Trap Server IP Address: This field allows the user to enter the IP address for the designated trap server.
Trap Ethernet Port: This control enables the user to select which network port is used to send alarm
messages to the designated trap server.
4.4.

TIMING

Figure 4-5: WebEASY - Timing
®

4.4.1. External Genlock Faults

External Genlock Fault Present: This display will turn red if a genlock fault is detected, remains green if
no genlock fault is found.
External Genlock Fault Send Trap: This slider control allows the user to enable sending a fault notice to
the trap servers enabled in Section 4.3.3. Slide the control to the right to enable trap, slide to left to disable.

4.4.2. Genlock Input Status

Genlock Health: This section displays the current genlock health, this is based on load increasing and jam
count not increasing.
Genlock Input Standard: This field displays the genlock input standard for the genlock input signal.
Page - 11
Revision 1.0